1968 Rear Body and Taillight Wiring Harness
1968 Corvette Rear Body & Taillight Wiring Harness. This harness also includes the wiring for 1968 rear fiber-optics.
Our Original Design Series™ wiring harnesses are manufactured exactly as the wiring was made when your vehicle left the factory in St. Louis. These harnesses are made to the exact O.E.M. (original equipment manufacturer) specifications, using the original factory blueprints, and are factory-correct in every way. These are full-assembled, ready to install, “plug & play” accurate reproduction wiring harnesses. You will NOT have to cut any wires, crimp any terminals, or make any modifications to these harnesses when installing them in your 1968 Corvette.
A commonly asked question and a much needed answer is "What does this harness" connect to?
1968 Corvette Rear Body & Taillight Wiring Harness Connects to:
- Dash Harness Connection
- Door Ajar Switch (driver & passenger side)
- Door Pillar Light or Interior Rear Compartment Light Harness Connection
- Fuel Tank Sending Unit (ground & return signal terminals)
- Ground (to frame)
- License Plate Light Assembly (power feed terminal & ground to license light housing screw)
- License Plate Light Fiberoptic Lens
- Rear Fiberoptic Lens (tail/stop light)(driver & passenger side)
- Rear Fiberoptic Monitor Lens (on console)
- Rear Lights (backup)(driver & passenger side)
- Rear Lights (inboard, tail/stop light)(driver & passenger side)
- Rear Lights (outboard, tail/stop light)(driver & passenger side)
- Rear Lights Ground (inboard, driver & passenger side)
- Rear Lights Ground (outboard, driver & passenger side)
- Rear Glove Compartment Light Switch Assembly (passenger side)
- Rear Side Marker Lights (driver & passenger side)
Also known under these part numbers: (For reference only)