1968 Corvette Engine Wiring Harness Big Block and Small Block Engines

Parts You Will Need

• 

  1968 Engine Compartment Nylon Tie Straps 11 Piece Kit All Engines

Parts We Recommend

• 

  1968 Dash Wiring Harness

• 

  1968 Headlight and Fiber Optics Wiring Harness

• 

  1968 Laminated Chassis Wiring Harness Diagram

• 

  1968 Rear Body and Taillight Wiring Harness

• 

  1968-1969 Turn Signal and Parking Light Extensions Wiring Harness

1968 Engine Wiring Harness Big Block and Small Block Engines

Over time, your 1968 Corvette's Engine Wiring Harness degrades and begins to fall apart. Our complete engine harnesses are a must have for authentic and accurate restoration projects. 

Our Original Design Series™ wiring harnesses are manufactured exactly as the wiring was made when your vehicle left the factory in St. Louis. These harnesses are made to the exact O.E.M. (original equipment manufacturer) specifications, using the original factory blueprints, and are factory-correct in every way. These are full-assembled, ready to install, “plug & play” accurate reproduction wiring harnesses. You will NOT have to cut any wires, crimp any terminals, or make any modifications to these harnesses when installing them in your 1968 Corvette.

A commonly asked question and a much needed answer is "What does this harness" connect to?

1968 Corvette Engine Wiring Harness Connects to:

• Air Conditioning Harness Connection
• Dash Harness Connection (at firewall)
• Ground (to starter motor mounting bolt)
• Heater Blower Motor (cars without A/C)
• Heater Blower Motor Ground Terminal (cars without A/C)
• Horn Relay
• Ignition Coil ("+" terminal)
• Starter Solenoid
• Windshield Washer Pump
• Windshield Wiper Door Limit Switch Connection
• Windshield Wiper Motor Connection
• Windshield Wiper Motor Ground Terminal

Also known under these part numbers: (For reference only)

• VIG6800