1968 Headlight and Fiber Optics Wiring Harness
Don't risk not having your headlights when you need them! Replace your worn or faulty headlight wiring harness immediately! Over time, your factory wiring harness begins to wear and develop cuts and shorts. Replace it with our direct fit 1968 Headlight and Fiber-optic Wiring Harness. Accurate reproduction harness that eliminates those pesky electrical problems from your Corvette!
Our Original Design Series™ wiring harnesses are manufactured exactly as the wiring was made when your vehicle left the factory in St. Louis. These harnesses are made to the exact O.E.M. (original equipment manufacturer) specifications, using the original factory blueprints, and are factory-correct in every way. These are full-assembled, ready to install, “plug & play” accurate reproduction wiring harnesses. You will NOT have to cut any wires, crimp any terminals, or make any modifications to these harnesses when installing them in your 1968 Corvette.
A commonly asked question and a much needed answer is "What does this harness" connect to?
1968 Corvette Connects to:
- Alternator
- Brake Pressure Warning Switch
- Dash Harness Connection (at firewall)
- Front Fiberoptic Monitor Lens (on console)
- Front Parking Light Assembly Connection (driver & passenger side)
- Front Parking Light Fiberoptic Lens (driver & passenger side)
- Ground (to alternator)
- Ground (to driver side radiator support)
- Ground (to header support)
- Ground (to horn relay mounting bolt)
- Ground (to voltage regulator mounting bolt)
- Headlights (driver & passenger side)
- Horn Relay
- Side Horn (driver & passenger side)
- Side Marker Light (driver & passenger side)
- Temperature Sending Unit
- Voltage Regulator
Also known under these part numbers: (For reference only)