Call Center Closed | 866.350.4535
You are just $149.99 from Free Shipping within the contiguous U.S.
Menu

Air Cooled VW 1967-1979 Body Molding Clips, 100 Pieces Bulk

  • Photos
product image
Brand Logo EMPI
Part #: 303-105
VW Part #: 113-853-585-C
Availability: In Stock - Ships today if ordered by 3 PM CT
Fits Years:
  • Standard Beetle 1967-1977
  • Super Beetle 1971-1979
  • Type 3 1962-1973
$19.99
subtract
add
share:
  • Description
  • FAQ

1967-1979 Body Molding Clips, 100 Pieces Bulk

Is your Air Cooled Volkswagen missing the body molding clips? Keep your Volkswagen's body molding secured with a fresh set of Body Molding Retaining Clips. Each set contains 100 clips, giving you plenty of clips to complete the job on your Volkswagen Beetle, Super Beetle or Type 3. 

  • 100 Piece Set

Application:

Standard Beetle 1967-1977 (42 needed)
Super Beetle 1971-1979 (42 needed)
Type 3 1967-1973 (34 needed)

Fits both Convertibles and Sedans


Note: These body side molding clips attach to holes on body first (thick end of clip goes into body). Tap or press the thinner shaft with a rubber mallet. This will cause the end that is in the body to spread out to hold the clip in place. After you have all of the clips on the body and before you put your molding on, press each clip with your thumb to make sure the thinner shaft does not pop out (this is so you do not damage your molding when you pop it onto the clips).

TECH TIP: Don't forget to pick up a set of body molding clip rubber boots to seal out any leaks or noise



Also known under these part numbers: (For reference only)

  • 113-853-585-C
  • 707924369045
  • 98-1052-B

Your body molding clips are usually ground off when you repaint your VW. Or a few of them may just break with age or from an impact.

Our body molding clips (and the body molding trims) are replaced this way:

1. First be sure the clip mounting holes in your body are free from body putty and paint clogging.

2. Press the bulb end of the molding clip into the hole in the body.

3. Now tap in the protruding shaft with a hammer or press in with a blunt tool. This will expand and lock the bulb end inside your metal panel.

4. The clip is now locked in place horizontally to the the ground and is ready for the installation of body molding.

5. To install body molding just lay the molding against the clips and snap the molding onto the clips and snap the molding onto the clips with your thumb or the heal of your hand.