1963-1965 Corvette C2 Engine Wiring Harness with Aftermarket AC

Photos

Part #: 617-874

Availability: In Stock - Ships today if ordered by 3 PM CT
Only 1 Left, Order Soon!

Fits Years:

1963-1965

$251.99 This Item is Not Eligible for Promotional Discounts

Add To:

Create List and Add Item:

Description

1963-1965 C2 Engine Wiring Harness with Aftermarket AC

1963-1965 Engine Service Replacement Wiring Harness. This is a service replacement part that fits all 1963-1965 with aftermarket AC: for use with alternator, voltage regulator, and horn relay re-located from passenger side to driver side.

Our Original Design Series™ wiring harnesses are manufactured exactly as the wiring was made when your vehicle left the factory in St. Louis. These harnesses are made to the exact O.E.M. (original equipment manufacturer) specifications, using the original factory blueprints, and are factory-correct in every way. These are full-assembled, ready to install, “plug & play” accurate reproduction wiring harnesses. You will NOT have to cut any wires, crimp any terminals, or make any modifications to these harnesses when installing them in your 1963-1965 Corvette.

A commonly asked question and a much needed answer is "What does this harness" connect to?

1963-1965 Corvette Engine Service Replacement Wiring Harness Connects to:

Alternator
Automatic Transmission (when applies)
Blower Motor (with aftermarket A/C)
Blower Motor Ground Terminal (with aftermarket A/C)
Dash Harness Connection (at firewall)
Ground (to horn relay mounting bolt)
Ground (to starter motor mounting bolt)
Ground (to voltage regulator mounting bolt)
Horn (driver & passenger side)
Horn Relay
Ignition Ballast Resistor (top screw terminal)
Ignition Coil ("+" terminal)
Starter Solenoid
Temperature Sending Unit
Voltage Regulator
Windshield Wiper Motor Ground Terminal

Also known under these part numbers: (For reference only)

VIG6365SR