1962 Engine Wiring Harness with Automatic Transmission
The 1962 Engine Wiring Harness with Automatic Transmission, connects to the ballast resistor, coil, temp sending unit, Automatic Trans. and starter under the hood. In the passenger compartment it connects to the ignition switch, ammeter and temp gauge.
Our Original Design Series™ wiring harnesses are manufactured exactly as the wiring was made when your Corvette left the factory in St. Louis. These harnesses are made to the exact O.E.M. (original equipment manufacturer) specifications, using the original factory blueprints, and are factory-correct in every way. These are full-assembled, ready to install, “plug & play” accurate reproduction wiring harnesses. You will NOT have to cut any wires, crimp any terminals, or make any modifications to these harnesses when installing them in your 1962 Corvette.
A commonly asked question and a much needed answer is "What does this harness" connect to?
1962 Corvette Engine Wiring Harness with Automatic Transmission, Connects to:
- Ammeter Gauge
- Ignition Ballast Resistor
- Ignition Switch
- Neutral Safety Switch Connection
- Starter Solenoid
- Temperature Gauge (passenger side terminal)
- Temperature Sending Unit
- Voltage Regulator ("Batt" terminal)
Also known under these part numbers: (For reference only)