BlazeCut Automatic Fire Suppression System 6 Feet Length
Protect your vintage VW Bus, Beetle or any vechicle for that matter with Blaze Cut. Protect your new paint from fire damage - best priced insurance you can buy!
BlazeCut is an Automatic Fire Suppression System that requires no wiring, switches, bottles or vehicle modifications to install. You can install Blazecut in 5 minutes using the included special high temp zip ties and instructions. Simply use the zip ties to install the extinguisher tube above the potential fire source and forget about it. This is an ideal solution for classic and modern cars, inboard boats or large outboards (install under the cover), motorized equipment like skid steers, back up generators and more. With no wiring and zip tie install you can protect your investment without drilling holes or modifying the electrical system!
When the temperature in the protected enclosure rises to a critical threshold, (sustained temp of 120*C or 248*F) the detection tube melts down at the point where the affecting temperature is the highest.
Blazecut is A.B,C rated.
It is recommended to check the functionality of the system by a simple pressure check: The system is under pressure and functional when the pressure indicator is above the value of 0 bar. The pressure indicator will change depending on the ambient temperature, the pressure at 20 Celsius is approximately 2 bar, and the pressure at 90 Celsius is approximately 10 bar. The system cannot slowly leak down or loose pressure like a conventional fire extinguisher, if you cannot see an air bubble in the line, the system is empty and should be replaced. Pressure should be checked in a warm engine compartment.
The FE-36 clean extinguishing agent does not leave a residue, conduct electricity, corrode or cause shock damage. This makes the clean agent solution the right choice for sensitive devices.